SUPER MICRO Computer Server AS1041M-82 Instrukcja Użytkownika Strona 69

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 104
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 68
Chapter 6: Advanced Chassis Setup
6-7
2. Installing/removing hot-swap SATA/SCSI drives
The SATA/SCSI drive carriers are all easily accessible at the front of the chassis.
These hard drives are hot-pluggable, meaning they can be removed and installed
without powering down the system. To remove a carrier, push the release button
located beside the drive LEDs. Then swing the colored handle fully out and use it
to pull the unit straight out (see Figure 6-5).
Note: Your operating system must have RAID support to enable the hot-plug ca-
pability of the SATA/SCSI drives.
Figure 6-5. Removing a SATA/SCSI Drive from the Server
SCSI/SATA Backplane
The SCSI/SATA drives plug into a backplane that provides power, drive ID and bus
termination. A RAID controller can be used with the backplane to provide data
security. The operating system you use must have RAID support to enable the
hot-swap capability of the drives. The backplane is already preconfi gured, so there
are no jumpers or switches present on it.
Przeglądanie stron 68
1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 103 104

Komentarze do niniejszej Instrukcji

Brak uwag